C-427 Parts and Pricing

PHASE I / PHASE II / PHASE III

PHASE I: FRAME PACKAGE
C-427

Frame Components:

1. Frame
2. 4 Point harness mount
3. Full-length 2" x 4" formed rails with 1" x 3" outriggers
4. Custom front cross member for stock Mustang II front end components
5. Universal engine and transmission mounting plates
6. Front sway bar mounting plates
7. Heavy-duty front end rear bumper mounts
8. Rear frame accepts stock Mustang coil spring differential
9. Custom lower control arms for 4-bar differential linkage
10. Heavy-duty cowl reinforcement frame with mounts for steering column and wiper motor
11. Motor mount brackets (specify engine)
12. Transmission cross-member (specify transmission)
13. Radiator support frame and frame mounting plates
14. Custom pedal set for power or manual brakes
15. Steering column extension package
16. Battery hold-down system
17. Phase I fastener package
18. Firewall with reinforced pedal mount and battery shelf
19. Left and right side pipes (unpainted single tube collector type)
20. 19 gallon fuel tank w/ sender and mounting straps with hardware
21.State of the industry wiring harness system. Offers simplicity ans unmatched dependability
22. Comprehensive assembly manual package with hundreds of pictures and illustrations

PHASE II: BODY PACKAGE
C-427

Body Components:
Note * Components #1 through 4 are pre-finished and laminated into the one-piece body before it is taken from the mold.

1. Left and right front fender liners
2. Trunk compartment
3.Defroster plenum and firewall tie-in
4. Upper radiator air scoop
5. Firewall close-off panels
6. Boot area tie-in with rear floor-pan
7. Hood with laminated inner liner (specify carbureted or EFI)
8. Left and right doors with laminated inner liners
9. Left and right fender liners
10. Trunk lid with laminated inner liner
11. Hood latch box
12. Transmission access cover
13. Foot well kick panels
14. Lower radiator scoop
15. Heavy-duty steel door hinge sets (2)
16. Heavy-duty steel side guard beams, jig-welded and installed in each door
17. Door latch to support frame brackets
18. Laser cut and jig-welded hood and trunk hinges
19. Approved door latches and door latch cables
20. Door strikers
21. Trunk latch
22. Authentic chrome plated brass windshield frame assembly with safety glass windshield
23. Phase II fastener package

PHASE III: COMPLETION PACKAGE
C-427

Completion Components:

1. Interior
2. Deluxe hand-crafted leather-grain vinal bucket seats
3. Deluxe leath-grain door panels with map pockets
4. Authentically-styled fiberglass dash with vinal cover
5. Complete carpet set: pattern cut, edged, and ready to install
     a) Kick panel covers
     b) Boot area
     c) Floor and firewall
     d) Trunk area
6. Lights
7. Left and right headlight assemblies with sealed beams and chrome bezels
8. Left and right front signal lights
9. Left and rights rear running lights
10. Left and right rear turn signal lights
11. License plate light
12. Flip-up 3" gas fillercap with vent and approved flexible hose with clamp
13. Adjustable seat tracks
14. Adjustable rubber stoppers for precise hood fit (4)
15. Extruded rubber edge seal for trunk